TLS Online TPP Program
More Questions
TLS Online TPP Program
#Question id: 15614
#Section 1: Engineering Mathematics
TLS Online TPP Program
#Question id: 15623
#Section 4: Fundamentals of Biological Engineering
Under unaerated condition in a fermentor, the power consumed by a single impeller was 10,000 W. The diameter of the impeller D is 1m and the density of the medium is 1000 kg/m3 and the stirrer speed is 1s-1. If one more impeller is added to the fermentor, power consumption would be approximately
TLS Online TPP Program
#Question id: 15624
#Section 4: Fundamentals of Biological Engineering
In heat transfer through a heat exchanger in co- current or counter-current flow, which of the assumptions is not correct ?
TLS Online TPP Program
#Question id: 15625
#Section 4: Fundamentals of Biological Engineering
A stagnant liquid film of 0.4 mm thickness is held between two parallel plates. The top plate is maintained at 400C and the bottom plate is maintained at 300C. If
the thermal conductivity of the liquid is 0.14 W/(m K), then the steady state heat flux ( W/m2) assuming one-dimensional heat transfer is
TLS Online TPP Program
#Question id: 15626
#Section 4: Fundamentals of Biological Engineering
In a mass transfer system the unit of diffusivity is
TLS Online TPP Program
#Question id: 15627
#Section 4: Fundamentals of Biological Engineering
A fermentation medium is being cooled from 700C to 320C in a double pipe heat exchanger. Fluid flowing counter currently with this stream in heated from 200C
to 460C. The log mean temperature difference (in0C) for the two streams is