Which one of the following biosensors is a type of biosensor based on transducer?

TLS Online TPP Program

#Question id: 14286

#Section 5: Bioprocess Engineering and Process Biotechnology

 When a liquid of density 1200kg/m3 and viscosity 0.01 kg m^-1s^-1 flows through a 1 cm ID pipe at 0.2m/s, the flow is referred as a 

TLS Online TPP Program

#Question id: 14287

#Section 5: Bioprocess Engineering and Process Biotechnology

A chemostat is run with a feed rate of llitre/h when the volume of the reactor is also 1 litre. At steady state the doubling time of the cells in the chemostat is.....   h. 

TLS Online TPP Program

#Question id: 14288

#Section 5: Bioprocess Engineering and Process Biotechnology

During a batch culture experiment the following data was obtained 

What will be the product yield (g) per gram of substrates?

TLS Online TPP Program

#Question id: 14289

#Section 5: Bioprocess Engineering and Process Biotechnology

In a fermenter the impeller diameter is increased from 0.5m to 1m and the rpm is increased from 100 rpm to 400 rpm. Reynolds number will increase by?

TLS Online TPP Program

#Question id: 14290

#Section 5: Bioprocess Engineering and Process Biotechnology

Acetobacter aceti converts alcohol to acetic acid according to the schiometric relation

In a vigorously agitated and aerated reactor containing 20 g/l ethanol, the organism produces 16g/l acetic acid and 2g/l was the residual ethanol concentration what are the theoretical and observed yields of acetic acid expressed in g/g ethanol

TLS Online TPP Program

#Question id: 14291

#Section 5: Bioprocess Engineering and Process Biotechnology

In a batch sterilization process if  overall,  heating &  cooling are 32.2, 9.8 & 10.1 respectively, THEN the holding time at 121^^o-C of the process is (given that the specific death rate (k) of microorganisms at 121^^o-C is 2.54 min-1 ):