TLS Online TPP Program

#Question id: 2012


The DGS-like phenotype can be produced in a specific knockout mouse for HA3, a Hox gene. HA3 is known to be involved in developmental regulation in the mouse. Which of the following would be an appropriate test for following the gene in the mouse progeny?

#Section 2: General Biology
  1. bone marrow biopsy

  2. assay for environmental agents known to cause birth defects

  3. chest X-ray

  4. measurement of the proportion of CD4 cells to total lymphocytes

More Questions
TLS Online TPP Program

#Question id: 12736

#Section 7: Recombinant DNA technology and Other Tools in Biotechnology

Match the following:
1. Emphysema                                                    i.  Fibroblasts
2. Immune System Disorder                        ii.  HPRT cLesch-Nyhan syndrome                           iv. T and B cells

TLS Online TPP Program

#Question id: 12737

#Section 7: Recombinant DNA technology and Other Tools in Biotechnology

 Name the technique which is used to detect abnormalities at an early stage.

TLS Online TPP Program

#Question id: 12738

#Section 7: Recombinant DNA technology and Other Tools in Biotechnology

Match  the following:
1. Growth Factors                                                    i. GTPase
2. Protein kinases                                                    ii. PDGF
3. G- Proteins                                                           iii. DNA binding protein
4. Nucleus located transcription factors      iv.Serine Kinases

TLS Online TPP Program

#Question id: 12739

#Section 7: Recombinant DNA technology and Other Tools in Biotechnology

Method used for gene editing and for the development in Gene modifications is known as_______.

TLS Online TPP Program

#Question id: 12809

#General Aptitude

The breadth of a rectangular hall is three-fourth of its length. If the area of the floor is 768 sq. m. then the difference between the length and breadth of the hall is:

TLS Online TPP Program

#Question id: 12819

#Section 2: General Biology

The length and breadth of a rectangle are increased by 20% and 25% respectively. The increase in the area of the resulting rectangle will be :