Increasing the agitation in a reactor increases oxygen transfer primarily because:

TLS Online TPP Program

#Question id: 27518

#Section 5: Bioprocess Engineering and Process Biotechnology

In a fermentation process, air sterilizer is used to reduce 1×108 to 1 microorganisms. The filtration efficiency will be

TLS Online TPP Program

#Question id: 14223

#Section 5: Bioprocess Engineering and Process Biotechnology

A furnace wall is constructed of firebrick 15-cm thick. The temperature inside the wall is 700⁰C the temperature outside is 80⁰C. If the thermal conductivity of the brick under these conditions is 0.3 W m-1 K^-1, what is the rate of heat loss through 1.5 m2 of wall surface?

TLS Online TPP Program

#Question id: 14436

#Section 5: Bioprocess Engineering and Process Biotechnology

Equation for Langmuir adsorption? 

TLS Online TPP Program

#Question id: 12909

#Section 7: Recombinant DNA technology and Other Tools in Biotechnology

According to the diagram, arrange the steps in correct order: 

1. DNA is then digested by the Cas9 nuclease at specific points on both DNA strands. 

2. Homologous recombination to repair the break and incorporate the new DNA sequence then follows. 

3.The nuclease Cas9 is targeted to DNA by a guide RNA consisting of a specific 20 nucleotide spacer/targeting sequence (crRNA).

 4. That identifies the DNA to be modified, linked to a trans-activating (tracrRNA) sequence necessary for the recruitment and stability of Cas9 nuclease.

TLS Online TPP Program

#Question id: 19486

#Section 4: Fundamentals of Biological Engineering

The growth of S.cerevisiae on glucose under anaerobic conditions can be described by the following reaction:

C₆H₁₂O₆ + aNH₃ → 0.59 CH_1.64N_0.16O_0.52 (biomass) + 0.43 C₃H₈O₃ + 1.54CO₂ + 1.3C₂H₅OH + 0.036H₂O 

and determine the product yield coefficient Y etoh/s and determine coefficient a.