TLS Online TPP Program

#Question id: 18600


A coin is tossed 6 times. The probability of getting exactly 2 heads is

#Section 1: Engineering Mathematics
  1. 1/3
  2. 1/2
  3. 15/64
  4. None of these
More Questions
TLS Online TPP Program

#Question id: 4845

#Section 3: Genetics, Cellular and Molecular Biology

Cross allowed between HHrr and hhRR , all progeny HhRr allowed to test cross would produced following progeny and there proportional , when H and R gene link at 10 map unit

TLS Online TPP Program

#Question id: 14182

#Section 5: Bioprocess Engineering and Process Biotechnology

Aerobic degradation of benzoic acid by a mixed culture of microorganisms can be represented by the following reaction.


                Determine the yield coefficients YX/O2

TLS Online TPP Program

#Question id: 4811

#Section 3: Genetics, Cellular and Molecular Biology

Three incompletely link gene as a B-A-C order. A cross allowed between AAbbcc X aaBBCC produce f1 progeny allowed test cross. Which of the following offspring is a result of double cross over?

TLS Online TPP Program

#Question id: 14236

#Section 5: Bioprocess Engineering and Process Biotechnology

Nutrient medium is to be heated from 10⁰C to 28⁰C is a single-pass countercurrent shell-and-tube heat exchanger before being pumped into a fed-batch fermenter. Medium passes through the tubes of the exchanger; the shell-side fluid is water which enters with flow rate 3 x 10^4 kg h^- 1 and temperature 60⁰C pre-heated medium is required at a rate of 50 m^3 h^-1. The density, viscosity and heat capacity of the medium are the same as water; the thermal conductivity of the medium is 0.54 Wm^- 1 ⁰C ^- 1. It is proposed to use 30 steel tubes with inner diameter 5 cm; the tubes will be arranged in line. The pipe wall is 5-mm thick; the thermal conductivity of the metal is 50 Wm^- 1 ⁰C^ - 1. The maximum linear shell-side fluid velocity is estimated as 0.15 m s^-1. What tube length is required? ____________

TLS Online TPP Program

#Question id: 14398

#Section 5: Bioprocess Engineering and Process Biotechnology

The internal effectiveness factor is useful because , which statement is not correct