TLS Online TPP Program

#Question id: 18764


which of the following statement is incorrect about loop modelling?

#Section 7: Recombinant DNA technology and Other Tools in Biotechnology
  1. In the sequence alignment for modelling, there are often regions caused by insertions and deletions producing gap sequence alignment
  2. In the sequence alignment for modelling, there are no regions producing gaps in sequence alignment
  3. The gaps cannot be directly modeled
  4. Loop modeling is required for closing the gaps requires
More Questions
TLS Online TPP Program

#Question id: 14364

#Section 5: Bioprocess Engineering and Process Biotechnology

Enzyme activity was monitored over the last two stages of an enzyme extraction-separation process. 0.4 g protein, from Stage 5, converted 46 mmol substrate in 10 sec, and 0.02 g protein, from Stage 6, converted 49 mmol in 30 sec. Calculate % increase in activity obtained over the two step  

TLS Online TPP Program

#Question id: 14365

#Section 5: Bioprocess Engineering and Process Biotechnology

0.1 mg of a quaternary structured enzyme (Mr 486 000) with four active sites converts 48 iimol substrate/10 sec. Calculate turnover number (min-1) 

TLS Online TPP Program

#Question id: 14366

#Section 5: Bioprocess Engineering and Process Biotechnology

0.1 mg of a quaternary structured enzyme (Mr 486 000) with four active sites converts 48 mirormol substrate/10 sec. Calculate molecular activity (min^-1), catalytic centre activity (min^-1). - 

TLS Online TPP Program

#Question id: 14367

#Section 5: Bioprocess Engineering and Process Biotechnology

During an enzyme purification, 0.23 g of protein was dissolved in 5 mL buffer. Suppose 0.5 mL of this solution converted 4.7 mmol of substrate in 30 sec. Calculate specific activity as units/mg protein - 

TLS Online TPP Program

#Question id: 14368

#Section 5: Bioprocess Engineering and Process Biotechnology

10 kg of a pure enzyme (Mr 30 000) catalyses the conversion of 1.5 g of a substrate (Mr 44) to products in 5 minutes. Calculate turnover number (sec^-1)  ....10^5

TLS Online TPP Program

#Question id: 14369

#Section 1: Engineering Mathematics

If the value of the determinant

  

then the value of